Stash Bee: Hive 2 - May Tutorial - Louisiana Pinwheels for Élise

Hi everyone! Thanks so much for being flexible and allowing me to be the Queen Bee a few months early while I recover from surgery.

A few months back I purchased this Mardi Gras Fat Quarter Bundle and knew the only way to properly use it was to do the state block.

This month we will be doing the Louisiana Pinwheel. The finished block will be 12.5 x 12.5.

Fabric Selection

I am looking for greens, purples and yellows. You can use any shade you like and they can be textures, blenders, batiks, grunges, etc.

You can also use white, but I'd prefer it to be white on white or a white that has one or more of the other colors in it. Solids are okay too, as long as the whole block isn't solid.

Cutting List

For one block you will need:

One - 7 1/4 inch square

Four - 3 1/2 x 6 1/2 rectangles

Four - 3 7/8 inch squares

Instructions

You can assemble your flying geese using whatever method you'd like, but I prefer the no waste method. I know these are supposed to be "no waste" but you will have to trim the finished geese a tiny bit.

Draw a diagonal line on the wrong side of each 3 7/8 in square.

Place one of the 3 7/8 inch squares in the corner of the 7 1/4 inch square right sides together and then layer another 3 7/8 inch square on top so that the diagonals line up. Pin the smaller squares in place.

Sew a scant 1/4 inch seam on each side of the line.

Cut in half along the drawn line.

Press the triangles open with the small triangles away from the large one.

Place a 3 7/8 inch square in the corner of each unit, right sides together, with the drawn lines going up and down. Pin in place.

Sew a scant 1/4 inch seam on each side of the diagonal line.

Cut in half along the drawn line.

Press the small triangles away from the large ones. You now have a small gaggle of geese.

Trim the geese to 3 1/2 inches x 6 1/2 inches. Leave a 1/4 inch seam at the top of the geese. If they end up being a little off, it's okay.

Pin a 3 1/2 inch by 6 1/2 inch rectangle to the top (point) of the flying goose, right sides together. Repeat for the other three geese. Sew a 1/4 inch seam along the long edge.

Press the seam allowance towards the rectangle.

Arrange the units as below. Sew the first row together using a 1/4 inch seam allowance. Repeat for the second row.

Pin the first row together and sew a 1/4 inch seam. Repeat with the second row.

Press the seam allowance on to top row toward the goose pointing to the right. Press the seam allowance on the bottom row toward the goose pointing to the right.